There are many reasons for the noise of dry electromagnetic brake, only to recognize what will cause the noise, in order to quickly remedy the problem, the following are some common noise fault causes and troubleshooting:

1. Check whether the friction plate is damaged: check whether the material adhering to the friction plate or the rivet head grinding holder of the riveting friction plate is normal. If not, the friction plate will fall off, which may cause direct contact between metal and metal in the process of braking. This will not only make the distance of the safety braking affected, will also cause greater damage to the rotor surface results, if this situation must be replaced with a new friction piece, and for the broken rotor to undertake the corresponding repair.

2.  Check the brake disc and the edge of the brake clamp whether there is sludge or rust phenomenon: the inspection should be cleaned, if rust, rust removal treatment, should be replaced in serious cases.

3.Check whether the brake clamp is right: the electromagnetic brake brake clamp is not right in the situation will cause the brake disc by the metal particles scrape ring, therefore, in the maintenance process must be carefully check, and if the brake clamp installation ear hole is not too smooth or is damaged had better replace new parts.

4.Check whether the bearing ring is fixed: check whether the bearing ring of the dry electromagnetic brake is fixed; if not, reinforce it.

If it cannot be solved, it can be sent back to the original manufacturer for repair. Tianji Transmission, 14 years electromagnetic brake clutch professional manufacturers, quality assurance, three months warranty for one year.

Now buy Noiseless electromagnetic brake :  http://www.tianjidg.com/list_34.html